CategoryTechnical Support
Technical Support
- Cisco GLC-LH-SM compatible ASF13-24-20-D 1000Base-LX SFP transceiver, 1310nm, 20KM I use it on Cisco 2960. It works fine for the first time, but it can’t work after I plug it out and test another transceiver. It said: HAS BAD CRC.
- Why the ASF13-24-10 1.25G SFP transceiver 10km works well on two H3C S5120V2, but can’t work on S5120V2-28P-SI and S5500V2-24P-S?
- I bought one piece SFP+ DAC 1 meter. It functions perfectly when connected with two Netgear switches, but it won’t work when I change one end to NAS (Network Attached Storage).
- Why the SFP+ DAC 1 meter can’t work with NIC card X520 on Netgear M4300, the other end is QNAP device?
- I bought NIC card X520-DA2. I connect it with transceiver after installed, but it does not work.
- AXS13-192-10 10GBASE-LR SFP+ 10KM module is applied to connect two 10 gigabit network cards. After the connection, the indicators of the NICs on both ends are on, but the ping is unreachable. What could cause this problem?
- The 10G SFP+ LR module is used to connect Huawei S5720S-28X-LI-AC and H3C S7003E (port No. 23), but there is no connection.
- I ordered 10GBASE-T transceiver ASF-10G-T. The EEPROM information cannot be open using the "ethtool -m" command, showing the following info.: “[cohesity@sv4-broadwell01-node-4 ~]$ ethtool -m ens802f0 Cannot get module EEPROM information: Operation not permitted”
- At November 2017 I ordered 1 piece of x540-T1 and x540-T2 for our QNAP Data Storage upgrade. Now I would like to order one X550-T1 for our new video editing PC. At the QNAP storage we installed X540-T2. One port is connected to a video editing machine with X540-T1. So the new editing machine will be X550-T1. I have seen the small led lights at the card when i plugged in the Ethernet cable. We are using Windows 7 Pro at that computer and used that driver to installed it.
- The QSFP+ BIDI transceivers were employed on Mellanox MLX-2700B (Cumulus IOS). There is no useful DOM information from the “ethtool-m” data.
- I bought one NIC card BCM57810 and one SFP+ DAC cable compatible with D-Link. I use this DAC cable to link this NIC card and D-Link switch DGS-1210-24, but it doesn’t work. The operating system is windows10 64bits.
- I bought an ASF-GE-T, 1.25G copper module. Now it’s used on the Cisco 3560cx switch, an error is reported. HomeSW# HomeSW# Jan 5 15:49:17.087: %PHY-4-SFP_NOT_SUPPORTED: The SFP in Gi1/0/15 is not supported Jan 5 15:49:17.087: %PM-4-ERR_DISABLE: gbic-invalid error detected on Gi1/0/15, putting Gi1/0/15 in err-disable state 」
- Is there any datasheet available for SFP-10G-T?
- I bought couple of 10G-SFP-T Transceiver. is it possible to supply programming interface, like the register map?